山東空壓機潤滑油管堵塞的原因都有哪些呢？

對于任何空壓機來說，空壓機專用油是空壓機的生命源動力。是整個空壓機工作運行中的必要保證。但是不免有很多客戶在空壓機運行中遇到油管堵塞問題。那么，山東空壓機潤滑油管堵塞的原因都有哪些呢？為防止其堵塞，在安裝過程中，我們需要做好哪些防范措施呢？

For any air compressor, air compressor special oil is the life source power of air compressor. It is the necessary guarantee of the whole air compressor operation. But there are many customers in the air compressor operation encountered tubing blockage problem. So, what are the causes of Shandong air compressor lubricating oil pipe blockage? In order to prevent its blockage, what preventive measures should we take in the installation process?

在安裝前一定要把油管洗干凈。

Be sure to clean the oil pipe before installation.

油管短不夠長的情況下，要是在接一塊的話應裝上活接頭。

If the tubing is short and not long enough, a union should be installed.

彎管時用煨管工具冷彎或氧乙炔火焰加熱煨彎，應注意防止煨扁或金屬過熱而變形。

When bending pipes, use pipe bending tools for cold bending or oxyacetylene flame for heating. Attention should be paid to prevent flat bending or deformation due to overheating of metal.

油管和注油器裝配好后，應進行系統的強度試驗，試驗壓力為操作壓力的1.5倍，當發現有滲漏或破裂時，應予以修理或更換。

After the tubing and oiler are assembled, the strength test of the system shall be conducted, and the test pressure shall be 1.5 times of the operating pressure. When leakage or rupture is found, it shall be repaired or replaced.

注油器與填料函、氣缸供油點接通前，應先將油器開動起來，在每一個供油點處檢查來油情況和清潔程度，直到清潔以后，再正式連上接頭。

Before connecting the oiler with the stuffing box and the oil supply point of the cylinder, start the oiler first, check the incoming oil condition and cleanliness at each oil supply point, and then formally connect the joint after cleaning.

很多小小的故障會(huì )引起大大的問題，但是只要我們做好良好的防范措施，很多不必要的麻煩也是可以避免的。

Many small failures will cause big problems, but as long as we take good preventive measures, many unnecessary troubles can be avoided.