【知識】山東干燥機的優缺點你了解多少？

您對干燥機有一些了解嗎？如果您對該設備有興趣的話，下面由山東清越來分析一下干燥機的優點和不足之處，希望對您有一定的幫助！

Do you know anything about dryers? If you are interested in the equipment, the following by Shandong Qing more and more analysis of the advantages and disadvantages of the dryer, hope to have some help for you!

山東干燥機的優點：

Advantages of Shandong dryer:

1.連續運行，熱效率高。連續干燥機以傳導傳熱方式進行干燥，干燥過程中干燥器內只通入極少量（或不通入）空氣，其尾氣攜帶量很少，故其熱效率可達65%以上。

1. Continuous operation, high thermal efficiency. In the process of drying, there is only a small amount of (or no) air in the dryer, and the amount of tail gas carried is very small, so its thermal efficiency can reach more than 65%.

2.動力消耗低、噪音小。由于干燥過程中料層很薄，主軸轉速低，物料傳送系統所需的功率小，電耗很少，其全套干燥裝置動力消耗僅是對流方式傳熱裝置動力消耗的1/5~1/7，且噪音很小。

2. Low power consumption and low noise. Because the material layer is very thin, the spindle speed is low, and the power consumption of the material conveying system is small, the power consumption of the whole drying device is only 1 / 5 ~ 1 / 7 of that of the convective heat transfer device, and the noise is very low.

3.物料受熱均勻，干燥時間短。由于干燥過程中物料在干燥盤中沿阿基米德螺線運動軌跡翻滾前進，物料所走路程為干燥盤半徑的5倍，且逐層下落，因此物料接觸加熱盤面時間基本相同，受熱很均勻。

3. The material is heated evenly and the drying time is short. In the drying process, the material rolls forward along the Archimedean spiral track in the drying plate, and the material walks 5 times of the drying disc radius, and falls layer by layer. Therefore, the contact time of the material on the heating plate surface is basically the same, and the heating is very uniform.

4.物料損失小、環境保護好。

4. Small material loss and good environmental protection.

5.干燥能力大。

5. High drying capacity.

6.設備密閉連續操作，工人勞動強度低。

6. Equipment closed continuous operation, low labor intensity of workers.

7.干燥介質可利用廢熱鍋爐所產生蒸汽，從而節省了大量的燃煤。

7. The drying medium can use the steam produced by waste heat boiler, thus saving a lot of coal.

8.產品質量穩定。

8. The product quality is stable.

山東干燥機不光有優點，也有不足之處：

Shandong dryer has not only advantages but also disadvantages

1.山東干燥機能耗相對是較低，但是設備的投資一般較高。

1. The energy consumption of dryer in Shandong is relatively low, but the investment of equipment is generally high.

2.山東干燥機的產量受其流量的限制，一般無法做大特別大，一般直徑在3米的干燥盤已經是很大了，基本是極限了。

2. The output of dryer in Shandong Province is limited by its flow rate, so it can't be large in general. Generally, the drying plate with a diameter of 3 meters is already very large, which is basically the limit.

3.山東干燥機的耙葉一般有損壞的經驗，定時要打開檢視門進行檢查。

3. The scraper leaves of Shandong dryer are generally damaged, so the inspection door should be opened regularly for inspection.

4.維修起來基本上以更換常見，耙桿，耙葉損壞就要更換。

4. The rake blade should be replaced after maintenance.

5.對于有粘性的物料，物料粘盤的物料一般不適合用山東干燥機。

5. For sticky materials, the materials sticking to the plate are generally not suitable for Shandong dryer.

總體而言，山東干燥機還是比較節能的，優勢也是相當明顯。

Generally speaking, Shandong dryer is more energy-saving, and its advantages are quite obvious.